metaruss

I got the rear brakes put back together, finally.  I originally took them apart to try to fix a squealing problem back there.  I believe it was due to a broken spring on one of the brake shoes.  I also wanted to bleed the brake system and flush it out with new fluid.  Even though the brakes and lines are suprisingly unrusty, the bleeder on the left side snapped off.  After breaking an extractor trying to get it out, I just replaced the cylinders on both sides (less than $10 each :).  Of course, the flare nuts were frozen to the brake lines (which weren’t even rusty), but I was able to spin the cylinder off the nut.  On the right side, the grease around outer bearing was contaminated with water and grit and the spindle nut was even rusty.  The dust cap seems OK, so I just flushed out all the grease with gasoline and repacked the bearings.  The races looked fine, so I didn’t bother replacing anything.  Some new brake hardware and grease seals later, it was all back together.

I always like to get into everything on a new (ha!) car to get a handle on where things are.  The shoes themselves seemed new and I know the front pads are new, so I should be good in the brake department.  Another thing that I thought was odd was that the emergency brake cables are NOT frozen!  The car is an automatic, so I doubt they were ever used.  For whatever reason, these cables are plastic-coated.  All of the ’87 Daytonas and Shadows I’ve seen were just steel and would rust within a year or two, while my ’88 had the coating.  This car gets weirder and weirder.